This stunning stamp is a whopping 6" x 6" red rubber, foam mounted background stamp. You may know that these big stamps have been very hard to stamp and get a good solid image. Thankfully, because of the Misti Stamping Tool, that is no longer an issue.
By removing the rubber mat inside the Misti to allow for the depth in the rubber and foam mount on the stamp, you get a perfectly stamped image each time. Check out the video below, I walk you through the steps for ink, and heat embossing.
Also due to the size of this stamp, with careful cutting, you can make two cards with one stamped and colored image. The one above is A2 finished sized, so I chopped off the left side at 4-1/4 x 5-1/2".
Which left a colored strip to create the "Spotlight" technique for my second card.
Here's the video walking you step by step through the stamping process and then I share a few coloring techniques I like to use with the Zig Markers.
I also have PDF downloads for both cards over on my blog if you would like them.
No comments:
Post a Comment
Thank you for taking the time to comment.